TM 1-5855-265-20
3-82
3-17. PNVS WINDOW COVER ASSEMBLY REPAIR
INITIAL SETUP
Tools
Aircraft armament repairman tool set
Aircraft armament repairman supplemental
tool set
Materials (appendix D)
Cord, shock absorber (Item 11)
(23 ± 0.25 inches)
Grommet assembly (Item 21)
Insulation sleeving (Item 22)
Streamer, warning (Item 30)
Tape, insulation (Item 31)
Wire, stainless (Item 38)
Personnel Required
68X Aircraft Armament/Electrical Repairer
References
TM 1-5855-265-T
Equipment Conditions
Ref
Condition
Para 3-9
PNVS window cover
assembly removed
FOLLOWUP
PNVS window cover replaced (para 3-9)
a. Remove old shock cord (1).
NOTE
If grommet replacement is not required, go to
step d below.
b. Remove loose or damaged grommet
assembly (2).
c. Install new grommet assembly (2).
d. Cut new shock cord to 23 ± 0.25 inches
e. Cut two pieces of insulation sleeving (3)
1.12 ± 0.12 inches long and slide to middle
of shock cord (1)
f. Loop shock cord (1) through warning
streamer (4) (left side only) then through
grommet assembly (2). Make loop length 2
+0.25 inches.
2"
312-033A
TOP VIEW
0.10"
0.10"
1
6
5
4
3
1
5
4
1
3
2
