(b) If necessary for replacement,
remove instruction plate (5), retaining ring (4), and
captive nut (1) from air cleaner element cover (2).
(c) Remove felt plug (10) from
carburetor chamber subassembly (38).
(d) Remove choke button (11) from end
of choke rod (14). Remove choke rod and rubber
grommet (12) from carburetor chamber.
(e) Remove governor link (20) from air
vane governor (19). Remove two screws (18), and air
vane governor (19) from beneath carburetor chamber.
(f) Remove and discard two screws
(21) securing reed assembly (22 through 24) to
carburetor chamber. Remove reed stop (22), reed
spring (23), and reed (24).
(g) Remove governor spring (15) from
throttle return spring clamp (17). Remove screw (16),
and throttle return spring clamp (17).
(h) Remove two throttle rod friction ad-
just screws (34) and springs (35) from outside of
carburetor chamber (38). Remove throttle rod clamp
Figure 11-18. Starter finger and torsion spring position.
(29) and washers (26).
(i) Remove setscrew (25) from throttle
c. Repair of Carburetor Chamber.
rod collar (27). Slide throttle rod (28) from throttle rod
Note:
collar, and from carburetor chamber. Remove throttle
This paragraph contains complete repair
rod collar from carburetor chamber.
instructions for the carburetor chamber,
(j) Remove rubber grommet (36) from
but not for the carburetor assembly.
carburetor chamber.
carburetor assembly repair instructions.
(a) Remove carburetor chamber group
11-29