Figure 11-17. Removal of magnets rotor.
(2) Installation.
ered end of the shaft.
(e) Install the flat washer (25), lock
(a) Position gasket (54, fig. 11-15)
washer (24), and nut (23) on the crankshaft.
against crankcase (22, fig. 11-20), and felt seal (53, fig.
(f) Secure the fabricated rotor locking
11-15) on crankshaft.
(b) Secure stator plate (52) to cylinder
tool to the magneto rotor as shown in figure 11-16.
Tighten the nut (23, fig. 11-15), to secure magneto rotor
(43, fig. 11-20) and crankcase with three screws (51, fig.
(30), with a 1/2-inch socket wrench.
(g) Remove rotor locking tool.
clockwise as far as possible to eliminate any play.
(h) Install starter fan housing assembly
(c) Place gasket (42, fig. 11-20) on
spark plug (41). Install spark plug in cylinder (43), and
(3) as described in step b (2), preceding.
attach high-tension lead (43, fig. 11-15).
e. Carburetor Chamber Group.
(d) Make sure the Woodruff key is
(1) Removal.
installed in the crankcase keyway. Line up the keyway in
(a) Turn captive nut (1, fig. 11-19)
the magneto rotor (30) with the key and start the rotor
onto the shaft. Push the rotor as far as possible by
counterclockwise and remove the air cleaner element
hand, so as to engage the tap-
cover (2), air cleaner element (3), and the mounting stud
gasket (6).
(b) Remove one cotter pin (13) and un-
11-25
