TM 55-1680-317-23&P
12-15. SRU-21/P SURVIVAL VEST-KIT-Continued
Figure 2-24. Removing the SRU-21/P survival vest inside panel.
6. Cut two lengths of 1-inch-wide pile-fastener tape equal in length to the original pile-fastener tape on the
left flap. Secure the two lengths of tape to the flap, next to the original tape length, by stitching according
to original construction details and paragraph 2-7, using the specifics in table 2-3.
(j) Altering vest to incorporate the ANIPRC-90 radio pocket. When required the SRU-21/P survival vest
may be altered to incorporate the AN/PRC-90 pocket. Vest alteration procedures are as follows:
1. Remove the first aid kit pocket and the one above it from the left front side of the vest. Remove the
vertical seams attaching the inside pocket and fold down. Use care while removing pockets, not to
damage vest body or pockets that will be rein- stalled.
2. Remove the antenna cover from the old radio pocket, the contents from the first aid kit and tourniquet
pockets may be installed in this pocket.
3. Position the new AN/PRC-90 radio pocket on the left side of the vest vertically, one inch from the zipper
closure and' one inch from the lower edge of the vest. Sew in place.
2-70
