and that control panel be in its outer position in control
alternate position (determined by alternate bolt hole
panel support (shown in phantom on figure 4-5). Adjust
positions in center support). Secure with bolts and nuts.
control panel position as follows:
(c) Place control panel in extended position.
(a) Remove nuts (4) and bolts (5) securing
Be sure tang of spring-loaded lock in folding brace
control panel (6) into control panel support (3). Slide
arm seats in slotted detent on other brace arm.
control panel to alternate position (determined by
(d) Select correct valve rod (10) to go
alternate bolt hole positions in panel and panel support).
between valve lever (11) and lever on control valve (25,
Secure with bolts and nuts.
on UH-1D. Refer to paragraph P24, step e(3) for
(b) Remove nuts (7) and bolts (8) securing
folding brace (1) to center support of tank support
instructions on attaching valve rod.
structure. Move folding brace connecting bracket (9) to
1 Folding brace
8. Nut, folding brace
2. Tank support center
9. Folding brace connecting
brace
bracket
3. Control panel support
10. Valve rod: (for UH-1B,
4. Nut, control panel
length 25 in. ) (for UH-
5. Bolt, control panel
1D, length 38 in. )
6. Control panel
11. Valve lever
7. Wing nut, folding brace
Figure 4-5. Alternate control panel positions.
4-9
