TM 1-8415-215-12&P
3-14. Inner Visor Knob.
INITIAL SETUP TABLE
TOOLS
MATERIALS/PARTS
PERSONNEL REQUIRED
General Aircraft
NONE
A.L.S.E.
Mechanics Tool Kit
Specialist/Technician
or Personnel with ASI
of H2/Q2 (ALSE Qualified)
NOTE
If this helmet is not equipped with nut plates (see paragraph 1-3), refer to paragraph 3-6 and
remove TPL.
Removal
1.
Remove front screw on the side where the visor knob is located.
2.
Loosen all remaining visor housing screws.
3.
Lifting upper track slightly, remove visor.
4.
Remove screws and posts attaching knob to visor.
Installation
1.
Install knob using screws and posts previously removed.
2.
Lift upper track slightly and reinsert visor into lower track. Reinstall front screw; tighten all screws securely.
3.
Test visor for proper operation.
4.
If TPL was removed, install per paragraph 3-6.
3-31
