TM 1-8415-215-12&P
3-19. Edge Beading.
INITIAL SETUP TABLE
TOOLS
MATERIALS/PARTS
PERSONNEL REQUIRED
Razor Blades
Cloth
A.L.S.E.
Rubber Adhesive
Specialist/Technician
Edge Beading
or Personnel with ASI
of H2/Q2 (ALSE Qualified)
Scissors
NOTE
Edge beading is already installed on the helmet shell. The sole purpose of this task is to
replace worn edge beading.
Replacement
1.
Peel worn edge beading away from helmet.
2.
Rub off old adhesive with clean cloth. Use razor blade, if necessary.
3.
Coat helmet edge and edge beading with synthetic rubber adhesive.
4.
Install beading evenly over adhesive. Allow to dry. Cut off excess edge beading with scissors.
5.
Rub off any excess adhesive with clean cloth.
3-36
