TM 1-8415-215-12&P
NOTES
Be sure to install spacers and tracks on the side of the housing (right or left) for which
they were configured. When installed correctly, these parts will curve toward the center
of the visor housing (see Figure 3-12.)
Some visor assemblies include nut plates to be installed between the posts and the
underside of the helmet shell to hold the posts in place. Steps 2 and 3 on the next page
describe the installation of the nut plate. The flat side of the nut plate (the side without
the prongs) must be installed facing the visor housing. Either edge of the nut plate - the
straight edge or the slotted edge - may face outward; in Figure 3-12, the straight edge is
shown facing outward.
Spacer, tracks, screws, posts, and nut plate are shown only on the left side of the
visor housing in Figure 3-12. A similar configuration exists for the right side.
Figure 3-12. Dual Visor Assembly (Exposed View)
3-27
