TM 1-8415-215-12&P
3-13. Outer Visor Lock.
INITIAL SETUP TABLE
TOOLS
MATERIALS/PARTS
PERSONNEL REQUIRED
General Aircraft
NONE
A.L.S.E.
Mechanics Tool Kit
Specialist/Technician
or Personnel with ASI
of H2/Q2 (ALSE Qualified)
Removal
1.
Move inner (neutral grey) visor down about halfway.
2.
Disassemble outer visor lock by removing center screw (left hand thread), lock key and washer.
NOTE
Push key down and rotate 1/4 turn to remove.
Installation
1.
Insert visor key through housing slot (on either side as desired) and into cutout in visor; push key down and
rotate a quarter turn counterclockwise to lock into place.
2.
Place washer and visor lock over visor key; install and tighten center screw of visor lock. Center screw has a
left-hand thread.
3.
Test visor for proper operation.
3-30
