TM 1-8415-215-12&P
3-12. Dual Visor Assembly.
INITIAL SETUP TABLE
TOOLS
MATERIALS/PARTS
PERSONNEL REQUIRED
General Aircraft
A.L.S.E.
Mechanics Tool Kit
Specialist/Technician
or Personnel with ASI
of H2/Q2 (ALSE Qualified)
NOTE
Disregard removal steps 3 and 4 if nut plates are installed in your helmet.
1.
Remove four screws attaching existing visor assembly to helmet shell.
2.
Ensure that moleskin guards have been installed on underside of visor housing as shown in Figure 3-11.
3.
Remove thermoplastic liner and energy-absorbing liner from helmet per paragraph 3-5, removal steps 1-3.
4.
Remove four posts that were secured to visor housing screws.
NOTE
If ANVIS NVG attachment is to be used, ANVIS mount must be installed on visor
housing before visor assembly can be assembled and installed. Proceed to paragraph
3-15 and complete the steps for installing the ANVIS mount. Then return to this
procedure.
Figure 3-11. Dual visor Assembly
3-26
