TM 1-8415-215-12&P
7.
Remove right or left front screw as desired. Use screw to lift upper track just enough to provide clearance for
inner visor knob. Slide inner (neutral grey) visor into lower tracks.
8.
Realign left (or right, as applicable) front tracks and spacer over post. Insert screw and tighten securely.
9.
Tighten remaining three screws securely.
10. Test outer visor operation by using outer visor lock. Test inner visor operation by using inner visor knob. If
either visor does not move freely, loosen screws, hold visor housing at sides, move housing side to side as required,
and re-tighten screws.
11. To move the outer visor lock from one side to the other, follow these steps:
(a) Move inner (neutral grey) visor down about halfway.
(b) Disassemble outer visor lock and remove key.
(c) Move visor key to cutout on other side of visor and install as in step 6. Assemble visor lock, washer, and
center screw as in step 6. Test visor for proper operation.
12. To move the inner visor knob from one side to the other, follow these steps:
(a) Remove front screw on the side where the visor knob is located.
(b) Loosen all visor housing screws.
(c) Lifting upper track slightly, remove visor.
(d) Remove screws and posts attaching knob to visor; 'move knob to holes on other side of visor and reattach
screws and posts.
(e) Remove front screw on other side; lift upper track slightly and reinsert visor into lower track. Realign front
of visor assembly and reinstall front screws. Tighten all screws securely. Test visors for proper operation.
3-29