TM 1-5855-265-20
2-14
3
RUBBER SEAL
NOTE
• Rubber seal is made of sponge rubber. The seal is compressed by
the access cover and forms an air and moisture seal around turret
assembly harness assembly where harness assembly exits the
aircraft interface assembly.
• When access cover is removed, about 3/8 inch of the seal is
visible. Do not push seal through hole in interface assembly. The
seal can not be pulled back through the hole without removing the
turret assembly (para 3-11) and reinstalling it (para 3-12).
3.1
X
Move TADS turret assembly (para 3-4) to 45° as shown. Loosen two
captive screws and remove access cover from rubber seal. Let
cover hang by wire rope.
3.2
X
Check seal for any tears, cracks, deterioration, and loose fit. If any
discrepancies are noted, replace rubber seal (para 3-18).
PREVENTIVE MAINTENANCE CHECKS AND SERVICES (cont)
Interval
Item
(hours)
Item to be Inspected
No.
250
Procedure
HARNESS
ASSEMBLY
RUBBER SEAL
ACCESS COVER
WIRE ROPE
CAPTIVE SCREW (2)
TURN
300-151
2-7. PMCS PROCEDURES (cont)
