TM 1-1510-225-10 3D-36 4.   Press the   ENT  button  to  approve  the waypoint    page.        The    DIRECT    TO  waypoint  identifier  in  the  active  flight plan    will    now    be    preceded    by    an arrow.    Refer  to  Figure  3D-47.  The         symbol is not displayed since there is no FROM waypoint. 2. ACT   2 GPT D V GULFPORT       L 109.00  2^o E N 30^o 24.40’ W 89^o 04.60’ E N R   -   L E G   1:KNEW   2:GPT   3:SJI   4:CEW   5:MAI   8:KPIE CRSR Figure 3D-45.  Select the DIRECT TO Waypoint DIRECT TO:   SJI VOR SJI D SEMMES       H 115.30  5^o E N 30^o 43.55’ W 88^o 21.56’ E N R   -   L E G E N T CRSR Figure 3D-46.  The DIRECT TO Waypoint NAV 1 E N R   -   L E G   1:KNEW   2:GPT   3:SJI   4:CEW   5:MAI   8:KPIE FPL 0     D SJI DIS  90.4NM GS    180KT ETE     :30 BRG    062^o +    +    +    +    +        +    +    +    +    + Figure 3D-47.  DIRECT TO Navigation (2)   An alternate method is to use the Super NAV 5 page to select the Direct To waypoint. 1.   Pull out on the right inner knob.  With the  inner  knob  out,  it  is  possible  to scan   through   the   waypoints   of   the active  flight  plan.    When  the  desired waypoint    is    highlighted,    press    the   D   button and then the  ENT button. 2.   To cancel  DIRECT  TO operation prior to reaching the  DIRECT  TO  waypoint in   order   to   proceed   along   the   flight plan  leg,  press  the    D    button,  press the  clear  button,  and  then  press  the ENT button. 3D-19.  DISTANCE/TIME PAGES. The distance/time pages are used with the active flight plan. a.   Distance/Time  1  Page.       When   the   FPL   0 page  is  displayed  on  the  left  side  and  the  D/T  1  page is   displayed    on    the    right    side,    the    distance    and estimated  time  en  route  are  displayed  for  each  of  the active flight plan waypoints.  The distance displayed is the   cumulative   distance   from   the   aircraft’s   present position  to  each  waypoint  along  the  flight  plan  route.   The ETE is displayed in hours and minutes.  Refer to Figure 3D-48.  If DIRECT TO operation is occurring to a waypoint that is not in the active flight plan, the D/T page is blank when the FPL 0 page is displayed on the left. Figure 3D-48.  Distance/Time 1 Page (1)   If     a     numbered     flight     plan     page     is displayed on the left side, the distances displayed are from   the   first   waypoint   in   the   flight   plan   and   have nothing to do with the aircraft’s position.  No ETE’s are shown. (2)   If  a  non-flight  plan  page  is  displayed  on the left  side,  the  format  of  the  D/T1  page  changes  to display   just   the   distance   and   ETE   for   the   active waypoint  and  for  the  last  waypoint  in  the  flight  plan.   Refer to Figure 3D-49.