TM 1-1510-225-10 3A-76 3.   Departure airport – Verify or insert valid identifier. NOTE If the first waypoint on the flight plan is an airport, the departure identifier pre-fills and the  cursor  will  be  positioned  over  the  SID field. If  the  first  waypoint  on  the  flight  plan  is  a runway,   the   RUNWAY   field   also   pre-fills and the cursor is over the SID field. If  there  are  no  SID's  associated  with  the departure   airport,   the   message   NO   SID's AVAILABLE appears and the ident field will flash.  Press the FPL key to return to active flight plan. 4.     BACK  key  –  Press  to  display  list of available SID's. 5.     Line select key  – Press to display list of available SID's. 6.     ENTER key – Press to select SID. NOTE Cursor moves to the TRANSITION field. 7.     BACK key  –  Press  to  display  list of available  TRANSITIONS. 8.     Line select key – Press to position cursor over the desired TRANSITION. 9.     ENTER   key    –   Press   to   select TRANSITION. NOTE If   the   SID   and   TRANSITION   are   runway dependent, and a runway has not pre-filled, the cursor moves to the RUNWAY field and the message RUNWAY REQUIRED appears.  10.      BACK key   –  Press  to  display  a list of applicable runways. 11.      Line     select     key     –     Press     to position  cursor  over  the  desired runway. 12.      ENTER   key    –   Press   to   select RUNWAY. 13.      Departure SID waypoints – Review,  then  press  the   ENTER key to insert SID into active flight plan    and    return    to    the    Active Flight Plan page. NOTE SID waypoints appear indented from other waypoints in a flight plan. (2)   Reviewing a SID. 1.   Line   select  key   –   Press   to   position cursor  over  the  DEPART  field  on  the Flight Plan page. 2.   ENTER key – Press to review SID. 3.   BACK key – Press. NOTE SELECT will not appear as an option since a SID already exists in the flight plan. (3)   Editing a SID. 1.   Line  select  key    –   Press   to   position cursor  over  the  DEPART  field  on  the Flight Plan page. 2.   ENTER key – Press. 3.   Line  select  key    –   Press   to   position cursor over the SID field. 4.   BACK key  – Press to display a list of alternate SID'S. NOTE A  list  will  only  appear  if  the  TRANSITION/ RUNWAY are compatible with other SID's.  5.   Line  select  key    –   Press   to   position cursor over the desired SID. 6.   ENTER key  – Press to select desired SID. 7.   ENTER key – Press to insert new SID into the flight plan. NOTE The  TRANSITION  and  RUNWAY  can  also be edited without changing the original SID by positioning the cursor over the appropriate  field  and  following  the  above procedure.