(4) Repeat step (3) using a slightly higher volt-
d. Turn assembly upside down to remove coil and
age setting each time on the variable transformer
pole piece assembly (9) from case (14), using spanner
until a minimum output voltage from the velocity
wrench, Part No. 28024-AE7.
vibration transducer assembly is obtained.
NOTE
Store coil and pole piece assembly (9) with
b. Remove cable assembly (4) from terminals on
largest diameter pole piece assembly as base
coil and pole piece assembly (9).
to reduce tension in spring.
c. Place assembly in oven for 5 minutes at 500F
e. When it is necessary to remove strain relief
before disassembling (9) through (14).
assembly (5) from cable assembly (4), mark wiring
for reconnection and remove solder so that strain
relief assembly (5) will be a slip fit from cable
assembly (4).
NOTE
Use extreme care when removing coil and pole
piece assembly (9) and cable assembly (4) from
Do not use sharp tools to remove solder from
case (14) so as not to damage terminal contacts.
the outer wire jacket.
