TM 55-1510-219-MTF
PROCEDURE
TROUBLESHOOTING
REFERENCE
2. Strobe beacon lights switch - Off.
NOTE
The engines must not be started until after the INS has been
placed into the NAV mode or OFF as required.
3. Propeller - Clear.
4. Ignition and engine start switch -
A1-7
ON. Propeller should begin to rotate and
associated IGN ON light should illuminate.
Associated
FUEL
PRESS
light
should
extinguish.
CAUTION
If ignition does not occur within 10 seconds after moving
condition lever to LOW IDLE, initiate ENGINE CLEARING
procedure. If for any reason a starting attempt is
discontinued, the entire starting sequence must be repeated
after allowing the engine to come to a complete stop (1
minute minimum).
5. Condition lever (after N1 RPM sta-
E1,J1
bilizes, 12% minimum) - LOW IDLE.
2-15
