TM 5-6630-218-10
2.3.4 Assembling the Sampler Valve Hose Assembly
a.
Insert the sampler base (with monitor in place) into the sampler
cover and screw the two pieces together to a snug hand-tightness.
CAUTION
Do not over-tighten or damage to the monitor or membrane may occur.
b.
Connect the bypass hose from the three-way valve to either bypass
port located on the sides of the base (Figure 2.5). Press the hose down
firmly into the port for a tight fit.
Figure 2.5 Inserting the Bypass Hose
into Sampler Base
2.3.5 Attaching the Remote Sampling Assembly to the Sampler
Valve Hose Assembly
a.
Screw the remote sampling assembly onto the sampler base.
b.
Force the nylon plug into the open port on the side of the sampler
base tightly plugging the port hole to prevent leakage (Figure 2.6).
2-6