TM 10-8415-206-12&P
4-30. NVG MOUNTING System No. 2
LOCATION/ITEM
ACTION
REMARKS
INSTALLATION - Continued
k.
Remove and retain screw (6).
l.
Clean Area using silicon car bide paper.
Sand lightly and remove dust with a clean
clot moistened with denatured alcohol.
m.
Coat the area with synthetic rubber
adhesive. Let dry and apply a second coat.
n.
Cut two 5-inch lengths of pile fastener tape.
Cut enough from each tape to Allow for the
screw (6). Coat the tape with synthetic
rubber adhesive. Let dry and apply a
second coat. When the coot becomes
cocky, install the tape to the helmet.
o.
In stall screw (6).
3.
Tubing Assembly
NOTE
Per form steps a thorough f twice to Install two clamps end develop two
snap release assemblies.
Change 1 4-98
