TM 10-8415-206-12&P
4-30. NVG MOUNTING System No. 2
LOCATION/ITEM
ACTION
REMARKS
INSTALLATION - Continued
f.
Coat the area with synthetic rubber
adhesive. Let dry and apply a second coat.
g.
Cut two 3-inch lengths of pile fastener tape.
Coat the tape with synthetic rubber
adhesive. Let dry and apply a second coat.
When the coat becomes tacky, install the
tape to the visor housing.
NOTE
Use screw (6) as the center line for the following measurements.
b.
Measure 2-inches on each side of the screw
(6) and mark. Repeat the measurements
just above the edge beading (7) and mark.
i.
Draw a 5-inch line from the edge beading on
each side of the screw.
j.
Draw a 4-inch line connecting the two lines.
NOTE
If additional pile fastener tape is required, it may be added to the
back of the helmet. A piece 4 x 5 is the minimum amount
required Additional tape may be added, for a larger size, to be
attached horizontally, but not overlapping to accommodate the
power pack and counterweight.
Change 4 4-97
