TM 10-8415-206-12&P
4-23.1 THERMO PLASTIC LINER (TPL) ASSEMBLY
LOCATION/ITEM
ACTION
REMARKS
INSTALLATION-CONTINUED
12. Visor housing
Fold a 3" X 3" piece of paper over
the helmet shell (2) covering the
installed pile fasteners. Place the
liner (1) into the shell (2),and remove
ONLY THE FRONT piece of paper.
NOTE
Ear cup assemblies must be removed in order to complete the installation
of the liner.
NOTE
Work with care to avoid damage to liner and assure that liner is properly
aligned with helmet shell.
13. Communication wire
Route the communication wire between
the Liner and Shell, to the appropriate
ear cup hole in the retention assembly.
Remove the rear piece of 3" X 3" piece
of paper.
NOTE
Hold liner away from shell slightly to enable routing ear cups.
Change 4 4-76.7