TM 10-8415-206-12&P
4-23.1 THERMO PLASTIC LINER (TPL) ASSEMBLY
LOCATION/ITEM
ACTION
REMARKS
INSTALLATION - Continued
10. Visor housing (1)
Mark a center line in the shell (1) in the
front and rear from the edge to the center
screw hole. Place the new energy absorbing
liner (2) in shell (1). Centering the liner.
Locate the position of the hook fasteners
on the liner and mark it on the shell center
line. Remove the liner and install the pile
fasteners (3) on the position lines just
marked in the shell.
11. Retention
assembly (1)
a. Reinstall retention assembly using mounting screws (3) into helmet (2).
NOTE
Earcup
assemblies
must
be
removed in order to complete the
installation of the liner
Change 4
4-76.6
