TM 10-8415-206-12&P
4-23.1 THERMO PLASTIC LINER (TPL) ASSEMBLY
LOCATION/ITEM
ACTION
REMARKS
INSTALLATION
6. Liner (1)
On the inside front edge of the energy
Insure that the pressure
absorbing liner (1 ) mark a center line.
sensitive tape has made
Peel off the protective paper from the
a good bond to the liner.
hook fastener (2) and place it 3-1/2 inches
from the center line. Repeat the procedure
on the opposite side of the center line.
7. Liner (1)
On the inside rear edge of the liner (1)
mark a center line. From the center line
make a mark approximately 2-112 inches
to the right and another mark 2-1/2 inches
to the left. Install the hook fasteners (2) in
the same manner as the front.
Change 4
4-76.4
