TM10-6640-216-13&P
4-31.
REMOVE/INSTALL ICE MAKER - continued.
b.
c.
d.
e.
f.
g.
h.
i.
j.
Wedge counter top up at cabinets 6 & 7. Insert tygon tubing in drain hole in the floor of
the laboratory. Slide ice maker in between cabinets No. 6 & 7 while feeding water
supply line and power cord into cabinet No. 6.
Secure ice maker to laboratory floor with two mounting screws.
Connect the water input hose (78 inch rubber tubing) and hose clamp to water line
piping inside cabinet No. 6.
Tighten hose clamp.
Secure countertop to cabinets No. 6 & 7 using four mounting screws. Install drawers 6
and 7.
Start the water pump and check for leaks.
Place the grill panel into the front panel.
Install two panel screws.
Plug in the ice maker power cord and verify proper operation.
NOTE
For Maintenance on the ice maker, refer to TM 10-6640-226-13&P.
4-86
