TM10-6640-216-13&P
4-31.
REMOVE/INSTALL ICE MAKER.
This task covers:
a. Removal
b. Installation
INITIAL SET-UP:
ToolsRequired
General Mechanics Tool Kit, Appendix B, Item 1
Materials/PartsRequired
Tygon Tubing,36 inches long, Appendix G, Item 4
Rubber Tubing 78 inches long, Appendix G, Item 5
General Safety Instructions
WARNING
ELECTRICAL SHOCK
Before performing any maintenance actions on electrical equipment
ensure all electrical power has been turned off. Death or serious
injury may occur from failure to do this.
REMOVAL
Remove ice maker. See figure 4-25.
a.
b.
c.
d.
e.
f.
g.
h.
i.
Unplug ice maker power cord located in receptacle at bottom of cabinet No. 6.
Shut down the water pump by placing the WATER switch to off.
Remove two screws from the bottom of the ice maker front grill panel.
Pull the grill panel forward and down and remove panel.
Loosen one hose clamp and disconnect water input hose from the water line piping inside
cabinet No. 6.
Remove two mounting screws.
Remove drawers 6 and 7 and remove four mounting screws securing countertop to
cabinets and wedge countertop up at cabinets 6 & 7.
Slide defective ice maker forward and remove.
Remove water supply and drain hoses from ice maker.
INSTALLATION
Install ice maker. See figure 4-25.
a.
Cut tygon tubing 3 inches long and rubber tubing 78 inches long (water supply line)
from bulk material. Install new water supply and tygon tubing and clamp to new ice
maker.
4-85