TM10-6640-216-13&P
4-30.
REMOVE/INSTALL LABORATORY OVEN.
This task covers:
a. Removal
b. Installation
INITIAL SET-UP
Tools Required
General Mechanics Tool Kit, Appendix B, Item 1
Rivet Gun, Appendix B, Item 3
Drill and Bits, Appendix B, Item 2
Materials/Parts Required
Rivets, Appendix F
General Safety Instructions
WARNING
ELECTRICAL SHOCK
Before performing any maintenance actions on electrical equipment
ensure all electrical power has been turned off. Death or serious
injury may occur from failure to do this.
REMOVAL
Remove laboratory oven. See figure 4-24.
a.
Unplug laboratory oven power cord.
b.
Remove twelve oven mounting screws.
c.
Remove oven and attached angle iron to a working surface.
d.
Drill out twelve blind pop rivets from the angle iron.
e.
Remove angle iron from oven and remove oven.
INSTALLATION
Install laboratory oven. See figure 4-24.
a.
On a working surface, place angle iron onto the new oven and drill 12 holes.
b.
Rivet twelve .188 in. diameter blind pop rivets, six on each side connecting angle iron to
the oven.
c
Place oven and attached angle iron on countertop above storage cabinet no. 5.
d.
Install twelve mounting screws, attaching oven to countertop.
NOTE
For maintenance on the laboratory oven, refer to TM 10-6640-219-
13&P.
4-83
