TM 1-1510-224-CL
13.
Altimeters - Set and check.
*TAXIING
1.
PROP levers - As required.
2.
Brakes - Check.
3.
Flight instruments - Check for normal operation.
ENGINE RUNUP
1.
Mission control panel - After receiving clearance from
IPF set as instructed.
2.
Propeller feathering - Check by pulling PROP levers aft
past detent to FEATHER. Check that each propeller
feathers, then advance levers to HIGH RPM position.
H3. Autofeather/auto ignition - Check.
H4. Overspeed governors and rudder boost - Check.
H5. Primary governors - Check.
6.
Engine anti-ice - Check.
H7. Anti-ice and deice systems - Check.
H8. Pneumatics/vacuum/pressurization - Check.
9.
WINDSHIELD anti-ice - As required.
H10. Weather radar - Test and set as required.
*BEFORE TAKEOFF
(1)
AUTOFEATHER switch - ARM.
(2)
PNEU & ENVIRO BLEED AIR valves (2) - As required.
(3)
ICE & RAIN switches - As required. As a minimum,
PITOT, STALL WARN, and FUEL VENT switches shall
be ON.
(4)
Fuel panel - Check fuel quantity and switch positions.
5.
Flight and engine instruments - Check for normal
indications and EFIS display controller is set to desired
setting.
(6)
CABIN CONTROLLER - Set.
7.
Annunciator panels - Check (note indications).
8.
Flaps - As required.
9.
Trim - Set.
N-7
