TM 1-1510-224-CL
ABORT START PROCEDURE
1.
CONDITION lever - FUEL CUTOFF.
2.
ENG START switch - STARTER ONLY.
3.
TGT - Monitor for drop in temperature.
4.
ENG START switch - OFF.
ENGINE CLEARING PROCEDURE
1.
CONDITION lever - FUEL CUTOFF.
2.
ENG START switch - OFF (15 minute minimum).
3.
ENG START switch - STARTER ONLY.
4.
ENG START switch - OFF.
*FIRST ENGINE START (GPU START)
1.
INS - Mode selector switch - OFF or NAV as
appropriate.
2.
3- AC CONTROL switches, AUTO and #2 INV - OFF.
3.
EXTERIOR LTS switches - As required.
4.
Propeller area - Clear.
5.
ENG START switch - START-IGNITION. IGN ON
annunciator
should
illuminate
and
FUEL
PRESS
annunciator should extinguish.
6.
CONDITION lever (after N, RPM stabilizes above 13%
minimum) - LOW IDLE.
7.
TGT and N, - Monitor (TGT 10000 C maximum).
8.
Oil pressure - Check (60 PSI minimum).
9.
ENG START switch - OFF after TGT peaks.
10.
CONDITION lever - HIGH IDLE. Monitor TGT as
CONDITION lever is advanced.
11.
DC GPU disconnect - As required.
12.
GENERATOR switch - RESET then ON, for second
engine battery start.
*SECOND ENGINE START (GPU START)
1.
Propeller area - Clear.
N-5
