TM 1-1510-223-10
8-16 Change 3
c. CABIN AIR MODE SELECT switch —
OFF.
d. ENG INLET LIP HEAT switches — OFF.
e. ICE VANE POWER SELECT switches (2)
— MAIN.
f. ICE VANE CONTROL switches (2) — ON.
g. ICE & RAIN switches — Off.
h. Exterior light switches — As required.
i. #1 and #2 EFIS POWER switches — Off.
j. AVIONICS MASTER POWER switch —
As required.
k. AUTO PLT POWER switch — Off.
l. #1 and #2 INVERTER switches — As re-
quired.
m. Environmental switches — As required.
n. AUTOFEATHER switch — OFF.
o. #1 AUTO IGNITION switch — Off.
p. #1 ENG START switch — OFF.
q. BATTERY switch — As required.
r. GENERATOR switches (2) — OFF.
s. #2 ENG START switch — OFF.
t. #2 AUTO IGNITION switch — Off.
* 4. Fuel panel switches — Check.
a. STANDBY PUMP switches (2) — Off.
b. AUX XFER SWITCHES (2) — AUTO.
c. CROSSFEED switch — OFF.
5. Magnetic compass — Check for fluid, heading,
and current correction card.
CAUTION
Movement of the POWER levers below the flight
idle gate with the engines not operating may
result in bending and damage to control linkage.
* 6. Pedestal controls — Set.
a. POWER levers — IDLE.
b. PROP levers — FEATHER.
c. CONDITION levers — FUEL CUTOFF.
d. Flaps — As required.
* 7. Pedestal extension switches — Set.
a. Avionics — As required.
b. RUDDER BOOST switch — On.
c. ELEV TRIM switch — On.
8. LANDING GEAR ALTERNATE EXTENSION
pump handle — Stowed.
9. Free air temperature gage — Check. Note cur-
rent reading.
10. Pilot’s instrument panel — Check and set.
a. MIC switch — HEADSET.
b. GYRO switch — SLAVE.
c. SYM GEN REV switch — NORMAL.
d. Display controller — As required.
e. Flight instruments — Check instruments
for protective glass, warning flags, and
static readings.
f. PROP SYN switch — OFF.
g. Engine instruments — Check instruments
for protective glass and static readings
11. Copilot’s instrument panel — Check and set.
a. Flight instruments — Check instruments
for protective glass, warning flags, and
static readings.
b. MIC switch — HEADSET.
c. GYRO switch — SLAVE.
d. SYM GEN REV switch — NORMAL.
e. Display controller — As required.
12. Mission control panel switches and circut
breakers — As required.
a. ELINT power — OFF.
