Figure 9. CEP Interface Harness Connected to Communications Cord.

MWO-1-8415-216-20-1 Modification of HGU-56/P Helmet Assembly Manual
Page Navigation
12

MWO 1-8415-216-20-1

(e) From outside the earcup, insert the interface harness into the newly drilled hole

and seat the grommet. (SeeFigure 8.) Pull additional wire through the grommet into the

earcup to make soldering connections easier.

(9 Carefully expose no more than 1/8 inch of bare wire at the pin connector on the

black communications cord either by sliding the insulation back or by stripping the insulation

away.

(g) If necessary, strip the black lead of the interface harness to 3/16 inch.

(h) Using long-nosed pliers, bend the stripped end of the interface harness into a

hook and fit the hook around the exposed wire of the black communications cord lead as shown

in the attachment detail in Figure 9.

COMMUNICATIONSCORD

INTERFACE HARNESS

Figure 9. CEP Interface Harness Connected to Communications Cord.

CAUTION

In step (I) below, use only rosin core solder when soldering t h e wires.