TM 5-6630-218-10
2.5.1.3 Installing the Quick-Release Valve
Follow the procedure for installing the quick-release valve as described in
Section 2.3.2. Refer to Figure 2.1.
CAUTION
Make sure that the pressure in the system does not exceed 100 psi. Damage to
the system fuel lines or components might result.
2.5.2 Preparing the Stainless Steel Monitor
a .
Pry open the top of the stainless steel monitor using the back end
of the tweezers (Figure 2.28).
Figure 2.28 Removing Stainless Steel Monitor Top
b.
Carefully remove the free-water test pad from its sealing package
using clean, dry tweezers. Take care not to touch the pad: oil from
your fingers may contaminate the dye.
2 - 3 2
