TM 10-8415-206-12&P
14-32. AN/AVS-6(V)1 AND (V)2 MOUNTING -Continued
LOCATION/ITEM
ACTION
REMARKS
INSTALLATION - AN/AVS-6(V)2 - Continued
5. Spacer Installation/Replacement
a. Tighten setscrew (31) until pad (32) on
spacer is almost flush with slot in visor
housing. Do not overtighten.
b. Tighten both spring clip screws (33).
c. Turn vertical adjustment knob (34) to
set mounting block at its lowest posi-
tion.
d. Align two holes in mounting block to
two holes in spacer (35).
e. Insert spacer screws (36 and 37) and
tighten.
f. Remove lower right-hand visor housing
attachment screw (38).
g. Place connector clamp (39) over screw
hole.
NOTE
Press finger against retaining nut Inside
helmet while remounting attachment
screw.
Change 1
4-133
