TM 10-8415-206-12&P
4-32. AN/AVS-6(V)1 and (V)2 MOUNTING - Continued
LOCATION/ITEM
ACTION
REMARKS
INSTALLATION - AN/AVS-6(V)1 - Continued
4.
Install or replace offset mount (AN/AVS-6(V)2).
a.
Use a flat table.
The offset mount
comes with spring
b.
Set and lock visor in full UP position
clip screws (21),
spacer screws (22),
c.
Remove both spacer screws (26)
setscrew (23), and a
from spacer (27).
spring clip (24) attached
to the spacer (25).
d.
Loosen but do not remove both spring
clip screws (28).
NOTE
Offset Mount fits onto the existing visor housing of SPH
4 helmet modified with helmet-mounted eight system.
e.
Slide spacer (27) up between visor housing (29)
and visor. Pad on the spacer must match slot (30)
in the visor housing.
f.
Match cupped part of spring clip (31) to lower edge
of helmet. Press up onto lower edge.
Change
14-132