TM10-6640-216-13&P
4-33.
REPAIR DISTILLATION UNIT - continued.
g.
Remove condenser assembly and attached angle iron to a working surface.
h.
Drill out twelve blind pop rivets from the condenser assembly angle iron.
i.
Remove angle iron from defective condenser assembly.
INSTALLATION
1.
Install condenser assembly. See figure 4-27.
a.
Place angle iron onto the new condenser assembly and drill twelve holes.
b.
Rivet twelve .125 in. diameter blind pop rivets, six on each side connecting angle iron, to
the assembly.
c.
Place the condenser assembly and attached angle iron on countertop above stortage
cabinets No. 1A and 2 and connect drain line.
d.
Install fourteen condenser assembly mounting screws, seven on each side of the unit,
attaching assembly to the countertop.
e.
Install the shield assembly.
2.
Install shield assembly. See figure 4-27.
a.
Place angle iron onto the new shield assembly and drill ten holes.
b.
Rivet ten .125 in. diameter blind pop rivets, five on each side connecting angle iron, to
the assembly.
c.
Place the shield assembly unit and attached angle iron on countertop above storage
cabinets NO. 1A and 2.
d.
Plug the shield assembly into the condense assembly receptacle.
e.
Carefully lift the assembly and connect it to the condenser assembly.
f.
Install ten mounting screws, five on each side of the unit, attaching assembly to the
countertop
g.
Plug in the condenser power cord and verify proper operations.
4-92
