TM 1-8415-216-12&P
CAUTION
When removing communications cord leads from the shell, earphone,
handle the grommet only; do not pull on the wires.
7. Carefully remove the grommet from the shell, earphone and pull the communica-
tions cord leads through the hole.
8. Inspect all components in accordance with Table 4-1, and replace as necessary.
Installation
1.
2.
Insert the communications cord through the hole in the shell, earphone.
Insert the grommet into the hole in the shell, earphone. For easier insertion, wet
the grommet with plain water if needed.
3.
Insert the communications cord leads into the receiver. Using a jeweler’s
screwdriver (Item 6, Appendix B), tighten the two set screws.
4.
Insert the cushion, ear lengthwise into the shell, earphone. Center it in the
shell, ensuring that the receiver and the communications cord leads are
accessible.
5.
Center the receiver in front of the cushion, ear. Insert the receiver retainer into
the earcup and center it so that the receiver is seated in the retainer pocket.
6.
Install the earseal on the earcup as follows: hook one end of the earseal over
the lip of the shell, earphone. Carefully stretch the earseal over the remainder
of the earcup.
7. Attach the shell, earphone to the earcup retainer pads. Ensure that the hook
and pile are firmly engaged.
8.
Check earcup position and adjust as necessary.
4-25
