TM 1-8415-215-12&P
3-6. Thermoplastic Liner.
INITIAL SETUP TABLE
TOOLS
MATERIALS/PARTS
PERSONNEL REQUIRED
General Aircraft
Tape, double-sided
A.L.S.E.
Mechanics Tool Kit
Specialist/Technician
or Personnel with ASI
of H2/Q2 (ALSE Qualified)
Removal
1. Remove liner per paragraph 3-5, Removal step 1.
2. Remove liner cloth cover as follows:
(a) Fold sides of cover down to expose double-sided tape.
(b) Remove cover from layer assembly.
(c) Remove double-sided tape from layer assembly.
Installation
1. Install liner cloth cover as follows:
(a) Cut two 2-1/2-inch pieces of double-sided tape.
(b) Attach a piece of tape to each side of layer assembly (where old tape was removed).
NOTE
Holes in plastic layers and label on cloth cover should be positioned toward the front of the helmet. (See
Figure 3-3.)
(c) Fold sides of replacement cloth cover back; place layer assembly against cloth cover; fold sides of cloth cover
over layer assembly.
(d) Reinstall liner per paragraph 3-5, Replacement step 2.
Figure 3-3. Liner Assembly
3-14
