TM 1-1510-225-10 3D-13 2.     Press  the  right  CRSR  button.    Make sure the right inner button is pushed to the in position. 3.     Rotate the right outer knob clockwise until    the    cursor     is    over    the    first character    in    the    VOR    name,    NDB name,   airport   name,   or   airport   city name. 4.     Turn  the  right  inner  knob  to  display the first character. 5.     Turn  the  right  outer  knob  one  step clockwise and then use the right inner knob to enter the second character. 6.     Use the right outer and inner knobs in the  same  manner  to  select  as  many characters as desired. (2)   Now    all    names    that    begin    with    the selected characters can be scanned. 1.     Pull  the  right  inner  knob  to  the  out position. 2.     Turn  the  right  inner  knob  (in  the  out position) to scan all names beginning with the selected characters. 3.     If  desired,  the  right  inner  knob  may be pushed back in and more characters added to the name. 4.     When  complete,  push  the  right  inner knob in and press the  CRSR button to turn off the cursor function. (3)   There are a few changes made to names in    order    to    accommodate    the    KLN    90B    display.   Names   that   are   too   long   to   fit   on   the   display   are abbreviated.      The   first   six   characters   are   usually exactly correct, with some exceptions.  Refer to Table 3D-3 for a list of exceptions. Table 3D-3.  Abbreviations North, Northern, East, Eastern, etc. N, E Southeast, Northwest, etc. SE, NW Point PT Port PT Fort FT Saint ST General GEN Table 3D-3.  Abbreviations 1.     Person’s   name    –   uses   initials   for other  than  last  name  unless  very  well known (Will Rogers). 2.     Delete    "City    of"    (City    of    Colorado Springs). 3.     Delete "Greater" (Greater Buffalo). 4.     Delete "The." (4)   Unless the first word is greater than eight characters, it is usually not abbreviated. (5)   Delete  most  punctuation  such  as  period and apostrophes. (6)   Abbreviations  for  International  are  INTL, INT, and IN. (7)   Abbreviations for Regional are REGL and REG. 3D-9.  DIRECT TO OPERATION. a.   The    D   button is used to initiate navigation from  the  present  position  direct  to  a  waypoint.    When the   D   button is pressed, the Direct To  page, Figure 3D-8, will be displayed on the left side with a flashing cursor    over    a    waypoint    identifier.        The    waypoint identifier that displays on the Direct To page is chosen by the KLN 90B according to the following rules. DIRECT TO:   KDEN CRSR Figure 3D-8.  Direct To Page (1)   If  the  flight  plan  0  page  is  displayed  on the left side and the cursor is over one of the waypoint identifiers  in  flight  plan  0  when  the      D      button  is