TM 1-1510-225-10 3A-82 NOTE SELECT will not appear as an option since an  APPROACH  already  exists  in  the  flight plan. An  APPROACH  CANCELED  message  will be   displayed   anytime   an   approach   has been altered. 3.   Line  select  key    –   Press   to   position cursor over the desired TRANSITION. 4.   ENTER key – Press. 5.   ENTER   key   –   Press   to   insert   new APPROACH into the flight plan. (8)   Erasing an Approach. NOTE Erasing     an     approach     also     erases     the destination airport. 1.   Line  select  key    –   Press   to   position cursor  over  APPROACH  field  on  the Flight Plan page. 2.   ENTER key – Press to display Approach page. 3.   Line  select  key    –   Press   to   position cursor over ERASE?. 4.   ENTER key – Press to erase   APPROACH  and  return  to  the  Flight Plan page. (9)   Deleting an Approach Waypoint. 1.   Appropriate Flight Plan page – Display. 2.   Line  select  key    –   Press   to   position cursor over the APPROACH waypoint identifier that will follow the new entry. 3.   BACK key – Press. 4.   ENTER key – Press. NOTE When     an     APPROACH     is     modified     by adding   or   deleting   waypoints   (including after the fence), the sequence of waypoints is no longer identified as an approach and the   aircraft   will   not   enter   the   approach mode. NOTE An  APPROACH  CANCELED  message  will be   displayed   anytime   an   approach   has been altered. (10)   Using  a  STAR  and  an  Approach  in  the Same Flight Plan.   Since both the star and approach procedures allow for entry of AIRPORT AND RUNWAY, the following rules apply. 1.   Changing the AIRPORT on the arrival page automatically erases the APPROACH procedure. 2.   Changing the AIRPORT on the Approach  page  automatically  erases the STAR procedure. 3.   Changing the RUNWAY on the Arrival page automatically erases the APPROACH procedure. 4.   Changing the RUNWAY on the Approach  page  has  no  effect  on  the STAR  procedure  unless  it  is  runway dependent. If the STAR  is runway dependent, the message SEL   RWY   FROM   STAR   PG   (select   runway   from STAR page) appears on the Approach page.  The pilot must    return    to    the    Arrival    page    to    change    the RUNWAY for the STAR before changing the RUNWAY on the Approach page. (11)   Modifying a Flight Plan. (a)   Accessing Desired Flight Plan.   This procedure may be used to modify the active flight plan or  any  stored  flight  plan.    Access  the  active  plan  or stored flight plan by pressing the  FPL key.  Access a stored flight plan from the alphabetized Flight Plan List page, using the  PRV or  NXT key to cycle through the available  pages.    If  necessary,  refer  to  the  procedure for flight plan selection under pre-departure. NOTE A   change   made   to   the   active   flight   plan does     affect     the     stored     flight     plan     in memory.    Any  change  made  to  a  stored flight plan remains in memory. (b)   Deleting a Waypoint. 1.   Line select key – Press to position the     cursor     over     the     waypoint identifier.