TM 1-1510-233-CL
N-6
3. ENG START switch – START - IGNITION. IGN
ON annunciator should illuminate and FUEL
PRESS annunciator should extinguish.
4. CONDITION lever (after N1 RPM passes 13%
minimum) – LOW IDLE.
5. TGT and N1 – Monitor (TGT 1000 C maxi-
mum.
6. Oil pressure – Check (60 PSI minimum).
7. ENG START switch – OFF after TGT peaks.
8. CONDITION levers – HIGH IDLE. Monitor
TGT as CONDITION lever is advanced.
9. PROP levers – HIGH RPM.
10. INVERTER switches – ON, check INVERTER
annunciators off.
11. Current limiters – Check.
12. Generator switch – Second switch RESET,
then ON.
13. BEACON lights switch – Reset, then as re-
quired.
ABORT START PROCEDURE
1. CONDITION lever – FUEL CUTOFF.
2. ENG START switch – STARTER ONLY.
3. TGT – Monitor for drop in temperature.
4. ENG START switch – OFF.
ENGINE CLEARING PROCEDURE
1. CONDITION lever – FUEL CUTOFF.
2. ENG START switch – OFF (15 minutes mini-
mum).
