TM 1-1510-223-CL
N-7
3. ENG START switch – STARTER ONLY.
4. ENG START switch – OFF.
*FIRST ENGINE START (GPU START)
1.
INS mode selector switch – OFF or NAV as ap-
propriate.
2. Exterior light switches – As required.
3. Propeller area – Clear.
4. ENG START switch – START-IGNITION. IGN
ON annunciator should illuminate and FUEL
PRESS annunciator should extinguish.
5. CONDITION lever (after N1 RPM passes 13%
minimum) – LOW IDLE.
6. TGT and N1 – Monitor (TGT 1000 C maxi-
mum).
7. Oil pressure – Check (60 PSI minimum).
8. ENG START switch – OFF after TGT peaks.
9. DC GPU disconnect – As required. Disconnect
if second engine is to be started utilizing the
Battery Start Procedure (Second Engine).
10. Generator switch – RESET then ON, for sec-
ond engine battery start.
*SECOND ENGINE START (GPU START)
1. Propeller area – Clear.
2. ENG START switch – START - IGNITION. IGN
ON annunciator should illuminate and FUEL
PRESS annunciator should extinguish.
3. CONDITION lever (after N1 RPM passes 13%
minimum) – LOW IDLE.
