TM 55-1510-219-10 d. Rotate   TEST   SEQUENCE   switch counter-clockwise to START/HOME position. NOTE When      the   TEST      SEQUENCE switch    is    turned    to    the    OFF position, the DISPENSER COMPLETE  lamp  will  extinguish, the   STRAY   VOLTAGE   lamp   will illuminate and then will extinguish when the OFF position is reached. 24. Install safety pins. 25. Disconnect test set power cable. 26. Remove M-91 test set from dispenser assembly and   restore   in   carrying   case   along   with   the power cable and hexagonal wrench. 27. On    DCP,    set    ARM-SAFE    switch    to    SAFE position. 28. On DCP, reset CHAFF counter to 30. 29. Disconnect  aircraft  power  by  pulling  the  M130 POWER  circuit breaker located on the mission control panel (fig.  4-1). 30. Proceed    immediately    to    ammunition    loading procedures. 4-5. AMMUNITION. a. Ammunition Loading Procedure. WARNING Only one shipping container is to be opened at a time.  If a shipping container   has   been   opened   and only partially emptied, the remaining contents will be secured  in  the  container  with  an appropriate    type    of    packaging material    or    filler    to    adequately prevent jostling.  All munitions in storage  must  be  in  their  original shipping containers. 1. Place   payload      module      assembly      on   work bench    in    approved    safe    area    so    that    the retaining plate is facing up. 2. Remove    retaining    plate    by    unscrewing    two retaining bolts. 3. Insert  one  flare  (or  chaff)  at  a  time  into  each chamber of payload module. 4. Remove    plastic  dust  cap  from  each  chaff  or flare. CAUTION Prior  to  insertion  of  an  impulse cartridge, be sure there is preformed   packing   in   the   flare cartridge.        (There    will    be    no preformed packing in chaff cartridges.) Reinstall any preformed packing that is inadvertently   removed   with   dust cap.        The    loading    of    impulse cartridges   into   a   flare   or   chaff shall   be   accomplished   one   at   a time. 5. Insert  one  impulse  cartridge  into  each  flare  (or chaff). 6. Install  retainer  plate  assembly  by screwing to two retainer bolts into payload module. WARNING The     system     must     have     been tested  to  assure  that  there  is  no stray     voltage     and     all     aircraft power  must  be  removed  from  the system    prior    to    unloading    the payload module. 7. On  the  dispenser  control  panel,  assure  ARM- SAFE switch is in SAFE position. 8. On the electronic module and right wing assure safety pins and flag assemblies are installed. 9. Slide  payload  module  assembly  into  dispenser assembly and secure two stud bolts, hand tight, using 5/32 inch hexagonal wrench. b. Ammunition Unloading Procedure. WARNING All aircraft power to the dispenser system must be turned off prior to removal  of  payload  module  from dispenser   assembly.   Safety   pin flag    shall    be    installed    in    the electronic module prior to landing and  the  safety  pin  flag  shall  be installed    in    the    wing-mounted safety    switch    immediately    after landing. 1. On    dispenser    control    panel,    assure  ARM- SAFE switch is in SAFE position. 4-9