TM 55-1510-219-10
8.
To load related arc-second
values for latitude -Press keys
in sequence, starting with "N".
(Example: 35.8" North = N 358.)
9.
INSERT/ADVANCE
push-
button- Press.
(Observe pushbutton light extinguishes.)
10.
To load related arc-second
values for longitude -Press
keys in sequence, starting
with "E".
(Example: 20.1" East = E 201.)
11.
INSERT/ADVANCE
push-
button - Press.
(Observe pushbutton light extinguishes.)
12.
Repeat steps 2 through 11 for
each waypoint to be loaded.
NOTE
In above example, if INSERT/
ADVANCE pushbutton was pressed,
the following normal display would
appear: "42°54.5 (N)" and 87°54.3(W).
The extra precision values are added
to normal values and normal data
displays are not rounded off.
NOTE
The normal geographic coordinates
must always be loaded prior to extra
precision values.
NOTE
The directions "N" or "S" and "E" or
"W" are established during normal
coordinate entry. Either key may be
used to initiate entry during extra
precision loads and values will be
added to the extra precision value
without affecting direction.
NOTE
It is characteristic of the computer
display routine to add "0.2" arc-
seconds to any display of "59.9" arc-
seconds. The value in computer is as
loaded by operator.
(11) To insert TACAN coordinates:
(a) Insertion of UTM TACAN station
data:
NOTE
Prior
to
pressing
the
INSERT/ADVANCE pushbutton, any
incorrectly
loaded
data
can
be
corrected
by
pressing
CLEAR
pushbutton and loading correct data.
1.
Data selector - UTM
WYPT.
2.
Keys "7" and "9" - Press
simultaneously.
(Observe that number of TACAN station being used
for navigation flashes on and off in "TO" display and
data displays indicate coordinates of station selected by
thumbwheel.)
3.
Thumbwheel - Set to number
of
station
to
be
loaded.
Confirm:
a.
Thumbwheel is in de-
tent.
b.
Station
"0"
cannot
be
loaded.
(Observe that if number of station to be loaded is
same as number of the TACAN station currently being
used, number in "TO" display will be set to "0" when
TACAN data is loaded.)
c.
To load zone and easting
- Press keys in sequence,
starting with "E".
(Example: Zone 16, 425 km East = E16 425.
Observe that zone and easting in kilometers appear in
the right display as keys are pressed.)
d.
INSERT/ADVANCE
pushbutton - Press.
(Observe that pushbutton light is illuminated.)
To load northing - Press keys in sequence, starting
with "N" or "S" to indicate north or south hemisphere.
(Example: 4749 km North = N 4749. Observe that
Northing kilometers appear in left data display as keys
are pressed.)
e.
INSERT/ADVANCE
pushbutton - Press.
(Observe pushbutton light remains illuminated.)
3-54