TM 55-1510-219-10 f. Takeoff and Climb Out. (1) Before takeoff 1.    Heading  marker  (pilot's  HSI)  Set  to runway heading. 2.    HDG    switch    (AP    mode    select panel)    Press.        Do    not    engage autopilot. (2) Takeoff   Pressing   the   PITCH   SYNC   & CWS  switch  on  control  wheel  will  provide  pitch  sync, and  the  cross-pointers  on  the  pilot's  horizon  reference indicator  will  command  flight  to  the  pitch  attitude  that existed   when   the   PITCH   SYNC   &   CWS   switch   was pressed. (3) Climb out. 1.    Establish climb profile. 2.    ENG/DIS   switch   (AP   mode   select panel)  Set  to  ENG  (above  200  feet AGL). 3.    IAS  switch  (AP  mode  select  panel) Press (if desired). 4.    HDG  knob  (pilot's  course  indicator selector)  Move  heading  marker  as required for heading changes. (4) Cruise altitude. 1.    Vertical   speed   Reduce   to   approx. 500   feet   per   minute   (just   before reaching cruise altitude). 2.    ALT button (AP mode select panel) Press (when reach cruise altitude). g. VOR Operation. (1) To  establish   aircraft   on   a   desired   VOR radial, perform the following 1.    VOR     receiver     Tune     appropriate frequency. 2.    COURSE    knob    (pilot's    HSI)    Set desired course TO or FROM station shown in COURSE window. 3.    HDG  knob  (pilot's  HSI)  Set  desired beam intercept angle under heading marker.    (The  intercept  angle  with respect  to  the  radio  beam  may  be any angle of 90°  or less). 4.    NAV switch (AP mode select panel) Press.        (Observe    illumination    of NAV ARM annunciator). 5.    NAV    CAP    annunciator    (AP/flight director annunciator panel) Monitor. (At    point    of    capture,    NAV    CAP illuminates). NOTE Except   as   described   below,   do not select a different VOR frequency,    TACAN    channel,    or course once a course and intercept have  been  programmed or  capture achieved.  To select a different   course   or   VOR/TACAN frequency,    return    to    the    HDG mode, select the course or frequency,     return     to     the     NAV mode,    then    reset    the    desired beam. (2) To change course over a VOR station. To change  course  over  a  VOR  station  while  operating  in NAV mode, if course change is less than 30°: COURSE knob   (pilot's   HSI)   Set   desired   heading   in   COURSE window. (3) To change course over a VOR station.  To change  course  over  a  VOR  station  while  operating  in NAV mode, if course change is greater than 30°: 1.    HDG  knob  (AP  mode  select  panel) Set desired intercept heading under heading marker. 2.    HDG switch (AP mode select panel) Press.    (Observe  HDG  illuminates (AP/flight director annunciator panel). 3.    COURSE knob (pilot's HSI) Set new course in COURSE window. 4.    NAV switch (AP mode select panel) Press (Observe NAV ARM illuminates (AP/flight director annunciator panel). 5.    NAV CAP (AP/flight director annunciator panel) -Monitor. (Illumination  means  capture  of  new radial). 3-40