TM 10-6640-216-13&P
4-12.
REMOVE/INSTALL WATER RESERVOIR DOOR - continued.
5.
Remove rain flaps. See figure 4-2.
a.
Remove five rivets from rain flap.
b.
Remove rain flap and retaining bar.
INSTALLATION
1.
2.
3.
4.
5.
Install door latch and wave washer. See figure 4-2.
a.
Install new wave washer and latch on spacer and fasten in place with flat washer,
lockwasher, and latch retaining screw.
b.
Tighten retaining screw.
Install latch keeper. See figure 4-2.
a.
Install new latch keeper and spacer plate on laboratory wall and fasten in place with two
retaining screws.
b.
Tighten retaining screws.
Install water reservoir door weatherstripping. See figure 4-2.
a.
Ensure all remnants of old weatherstripping are removed from door bonding surface and
surface is clean.
b.
Cut sufficient weatherstripping from bulk material to replace old weatherstripping.
c.
Align weatherstripping bonding surface and firmly attach to door.
Install water reservoir door. See figure 4-2.
a.
Align new door hinge with rivet holes on laboratory wall.
b.
Rivet door in place.
c.
Close water reservoir door and secure with door latch.
Install rain flap. See figure 4-2.
a.
Cut replacement rain flap from bulk material listed in Appendix G.
b.
Align rain flap and retain bar with rivet holes on laboratory wall.
c.
Rivet retaining bar and rain flap in place
4-21
