TM 10-6640-216-13&P
4-14. REMOVE/INSTALL BLOWER EXHAUST DOOR.
This task covers:
a. Removal
b. Installation
INITIAL SET-UP:
Tools Required
General Mechanics Tool Kit, Appendix B, Item 1
Drill and Bits, Appendix B, Item 2
Riveter, Hand, Appendix B, Item 3
Materials/Parts
Rivets, Appendix F
Weatherstripping, Appendix G, Item 1
Equipment Conditions
Power to exhaust blower turned OFF. Paragraph 4-18
REMOVAL
1.
2.
3.
4.
5.
Remove door latch and wave washer. See figure 4-4.
a.
Remove latch retaining screw, lockwasher and flat washer.
b.
Remove defective latch and wave washer.
Remove latch keeper. See figure 4-4.
a.
Remove two latch keeper retaining screws.
b.
Remove defective latch keeper and spacer.
Remove panel keeper. See figure 4-4.
a.
Drill out four rivets attaching panel keeper to door.
b.
Remove panel keeper.
Remove blower exhaust door weatherstripping. See figure 4-4.
a.
Remove defective weatherstripping from door.
b.
Ensure that there are no weatherstripping remnants left adhering to door bonding
surface.
Remove blower exhaust door. See figure 4-4.
a.
Remove six rivets from door hinge.
b.
Remove door from laboratory.
4-26
