TM 10-6640-216-13&P
4-12.
REMOVE/INSTALL WATER RESERVOIR DOOR.
This task covers:
a. Removal
b. Installation
INITIAL SET-UP
Tools Required
General Mechanics Tool Kit, Appendix B, Item 1
Drill and Bits, Appendix B, Item 2
Riveter, Appendix B, Item 3
Materials/Parts Required
Wave Washer, Appendix F
Rivets, Appendix F
Lockwasher, Appendix F
Rubber Sheeting 2 inches X 8 inches, Appendix G, Item 2
Weatherstripping, Appendix G, Item 1
REMOVAL
1.
Remove door latch and wave washer. See figure 4-2.
a.
Remove latch retaining screw, lockwasher and flat washer
b.
Remove latch and wave washer from door.
2.
Remove latch keeper. See figure 4-2.
a.
Remove two keeper retaining screws.
b.
Remove latch keeper and spacer plate.
3.
Remove water reservoir door weatherstripping. See figure 4-2.
a.
Remove defective weatherstripping from door.
b.
Ensure that there is no weatherstripping remnants left adhering to door bonding
surface.
4.
Remove water reservoir door. See figure 4-2.
a.
Remove five rivets from door hinge.
b.
Remove defective door from laboratory.
4-19
