TM 10-6640-216-13&P
3-8. REMOVE/INSTALL FLASH POINT TESTER UNIT.
This task consists of:
a. Removal
b. Installation
INITIAL SET-UP
Tools Required
Cross-Tip Screwdriver, Appendix C, Item 86
Equipment Condition
Drawer No. 7 Removed.
General Safety Instructions
WARNING
ELECTRICAL SHOCK
Before performing any maintenance actions on electrical equipment
ensure all electrical power has been turned off. Death or serious
injury may occur from failure to do this.
REMOVAL
Remove Flash Point Tester Unit. (Figure 3-5).
a.
Unplug the power cord from wall receptacle.
b.
Remove three mounting screws from base and countertop and remove defective flash
point tester.
INSTALLATION
Install Flash Point Tester Unit. (Figure 3-5).
a.
Place new flash point tester unit on countertop to align with mounting holes and install
three mounting screws.
b.
Plug the power cord into wall receptacle.
3-21
