TEMPLATE INSTRUCTIONS
Cut out the template. Cut out the screw locator circle (above the notation PLACE THE PROPER SCREW
HOLE OVER THE RIGHT REAR RETENTION SCREW) for your helmet size.
Cut an X through the “DRILL CENTER MARK” circle for your helmet size.
Making sure the template conforms to the shape of helmet, place large hole that you cut out over the re-
tention screw.
Align the curve on the left with the helmet cap plug (if it exists).
Align the bottom curve of the template with the bottom edge of the helmet shell.
Mark the drill location in the center of the “Drill Center Mark” hole where you cut the X.
IF YOU MUST PHOTOCOPY THE TEMPLATE, ENSURE THAT THERE IS NO SIZE VARIATION
BETWEEN THE PHOTOCOPY AND THE TEMPLATE.
Figure B-3. CEP Template
Change 3
B-9/(B-10 blank)
TM 1-8415-216-12&P
