TM 1-1510-225-10 3D-27 T Terminal U Undefined (5)   The VOR frequency. (6)   The  published  magnetic  variation  of  the VOR. (7)   The latitude and longitude of the VOR. The nine VOR’s nearest to the aircraft’s present position   may   be   displayed.      When   a   VOR   page   is displayed as part of the nearest VOR list, the latitude and    longitude    is   replaced    with    the    bearing    and distance to the VOR. NOTE NDB's    which    are    combined    with    outer markers (compass locators) are usually not stored   with   NDB's.      However,   they   are always   stored   with   intersections   and   are found  on  the  INT  page  by  using  the  outer compass    locator    name,    not    the    NDB identifier.  There is also a nearest NDB list.   When an NDB page is displayed as one of the nearest NDB's, the latitude and longitude are replaced with the bearing and distance to the NDB. 3D-14.  NDB PAGE. a.   NDB Page Display.  Refer to Figure 3D-26.   OWI OTTAWA FREQ    251 N 38^o 32.55’ W 95^o 15.26’ NDB Figure 3D-26.  NDB Page (1)   The  NDB  identifier.    An  arrow  precedes the identifier if it is the active waypoint. (2)   The name of the NDB. (3)   The NDB frequency. (4)   The latitude and longitude. 3D-15.  INTERSECTION PAGE. a.   Intersection Page Display.   The intersection pages  contain  the  named  low  altitude,  high  altitude, approach,   and   SID/STAR   intersections   as   well   as outer  makers  and  outer  compass  locators.    Refer  to Figure 3D-27. (1)   The  intersection,  outer  marker,  or  outer compass locator name. KENZY REF:  MKC RAD: 152.2^o DIS:  3.7NM N 39^o 13.25’ W 94^o 33.84’ INT Figure 3D-27.  Intersection Page (2)   The   location   of   the   intersection,   outer marker, or outer compass locator expressed in terms of a radial and distance from a nearby VOR.  The KLN 90B chooses the closest VOR.  It takes a few seconds for the VOR ident, radial, and distance to be calculated and displayed. (3)   The latitude and longitude of the intersection,  outer  marker,  or  outer  compass  locator.   The  identifier  of  another  VOR  may  be  entered  in  the REF  field  and  the  page  will  compute  and  display  the radial and distance from that VOR to the intersection.   This information is not stored with the INT page and is lost when leaving the page. 1.     Display the desired intersection page. 2.     Press  the  right  CRSR  button  to  turn on the cursor function. 3.     Rotate  the  right  outer  knob  until  the cursor is positioned over the identifier adjacent to REF. 4.     Use the right inner and outer knobs to select the desired identifier.