TM 1-1510-225-10
3A-100
FPL
FUEL
are
recalculated
whenever the FLOW changes.
d. FUEL FLOW is changed on Fuel
Status page.
NOTE
The REM@ field only appears when a
DIRECT TO leg is displayed.
Information
between
any
desired
waypoints can be reviewed by selecting
the Fuel Plan page and entering a FROM
TO leg or by executing the present position
direct procedures. If the TO waypoint is
not on the selected flight plan, the flight
plan number and origin/ destination fields
will display dashes.
15. Remainder of flight plan Review by
positioning cursor over TO field then
pressing ENTER key twice to call up
the next leg. Groundspeed and/or fuel
flow should be updated if necessary.
16. With an active flight plan selected to
update the FUEL PLAN leg to current
TO waypoint, perform the following.
a. Line select key Press to position
cursor over FUEL PLAN A field.
b. Letter A Enter in cursor field.
c. ENTER key Press twice to
display information in data fields.
The FUEL PLAN leg displays DIRECT TO the
current navigation page TO waypoint.
Selecting another display page, other than MSG
and Trip Plan, and returning to Fuel Plan page also
updates the leg with DIRECT TO the current
navigation page TO waypoint.
(4) Verifying Or Changing Date And Time.
NOTE
If necessary, both DATE and GMT can be
corrected on this page.
GMT may be updated to GPS time by
placing the cursor over the GMT data field
and pressing BACK key. If GPS time is
available, GPS? will appear under the
cursor. Press ENTER key to update GMT
to GPS time.
(a) DATE. This field displays current
date same as Initialization page.
(b) GMT. This field displays current
GMT same as Initialization page.
NOTE
TAKEOFF and LAND may be based on
groundspeed and/or TAS depending upon
system configuration.
(c) TAKEOFF. This field displays the
GMT at weight off wheels.
(d) LAND. This field displays the GMT
at weight on wheels.
(e) FLIGHT TIME. This field displays the
elapsed flight time in hours and minutes.
(5) Verifying Or Changing Aircraft Weight
Parameters. This procedure allows the pilot to confirm
or adjust basic operating weight, payload, or fuel to
current on board data.
1. PLAN key Press to display
Aircraft Weight page.
NOTE
BASIC OP WT, PAYLOAD, and FUEL ON
BOARD fields will be blinking if update has
not been entered after system power up.
FUEL USED will remain dashes until auto
fuel flow is detected.
2. Line select key Press to place
the cursor over flashing weight
field.
3. BASIC OP WT Verify or insert.
4. ENTER key Press.
5. PAYLOAD Verify or insert.
6. ENTER key Press.
7. FUEL ON BOARD Verify or
insert.
8. ENTER key Press.
NOTE
VERIFY INPUTS field will disappear and a
GROSS WT value will replace dashes, and
weights will no longer blink.