TM 1-1510-223-10 NOTE When    turning    the    TEST    SEQUENCE switch to the OFF position, the DISPENSER COMPLETE annunciator will extinguish, the STRAY VOLTAGE annunciator   will   illuminate   and   then   will extinguish    when    the    OFF    position    is reached. 6. Install safety pins. 7. Disconnect test set power cable. 8. Remove  M-91  test  set  from  dispenser assembly  and  restore  in  carrying  case along  with  power  cable  and  hexagonal wrench. 9. On     MFD,     depress     L3     until     SAFE appears. 10. Reset CHAFF counter to 30. 11. Disconnect  aircraft  power  by  pulling  5- ampere M130 circuit breaker located on mission control panel (fig.  4-1). 12. Proceed    immediately    to    ammunition loading procedures. 4-4.    AMMUNITION. a. Ammunition Loading Procedure. Only one shipping container is to be opened at a time.  If a shipping container has been opened    and    only    partially    emptied,    the remaining  contents  will  be  secured  in  the container    with    an    appropriate    type    of, packaging   material   or   filler   to   adequately prevent  jostling.    All  munitions  in  storage must be in their original shipping containers. 1. Place    payload    module    assembly    on work  bench  in  approved  safe  area  so that the retaining plate is facing up. 2. Remove  retaining  plate  by  unscrewing two retaining bolts. 3. Insert one flare (or chaff) at a time into each chamber of payload module. 4. Remove   plastic   dust   cap   from   each chaff or flare. Prior to insertion of an impulse cartridge, be sure   there   is   a   preformed   packing   in   the flare cartridge.  (There will be no preformed packing  in  chaff  cartridges.)  Reinstall  any preformed    packing    that    is    inadvertently removed   with   dustcap.      The   loading   of impulse cartridges into a flare or chaff shall be accomplished one at a time. 5. Insert  one  impulse  cartridge  into  each flare (or chaff). 6. Install retainer plate assembly by screwing    the    two    retainer    bolts    into payload module. The    system    must    have    been    tested    to ensure that there is no stray voltage and all aircraft  power  must  be  removed  from  the system prior to loading the payload module. 7. MFD - Bring up ASE page and depress L3 to change dispenser to SAFE. 8. On  right  equipment  rack,  ensure  safety pins and flag assemblies are installed. 9. Slide    payload    module    assembly    into dispenser assembly and secure two stud bolts, using 5/32-inch hexagonal wrench. b. Ammunition Unloading Procedure. All  aircraft  power  to  the  dispenser  system must   be   turned   off   prior   to   removal   of payload  module  from  dispenser  assembly. Safety pin flag shall be installed on the right equipment   rack   prior   to   landing   and   the safety pin flag shall be installed in the wing- mounted   safety   switch   immediately   after landing. 1. MFD - Bring up ASE page and depress L3 to change dispenser to SAFE. 2. Assure  safety  pin  and  flag  are  inserted in   right   equipment   rack   and   in   wing mounted safety switch 4-9